Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new batteries? Going from 12V to 18V or 6V to 12V? Wiring Questions?
User avatar
By VirgoDad
#148318
I have an older 12v fire truck I am trying to fix. KT1003 Wiring and switches all appear to be okay. Tested using multimeter. Measured 12.8v at the battery, board terminal and 3 relays. I don’t get any power readings at the 10pin connector to the starter and steering wheels controls. Try jumping bypass starter no luck. Seen many people mod and upgrade on this forum. Any input would be a great help. I did get the service manual and checked everything. Not sure if the board is bad.
Need wiring help

Note that diagram shows the accelerator as a poten[…]

Motion Trendz Buzz Lightyear Car

So has anyone found a good place to find these gea[…]

Dune racer build up help

You can go with the Banebots with either tooth opt[…]

Exploding Controllers

I would double-check the battery/wiring polarity -[…]

HobbyMasters Udemy Course