Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new batteries? Going from 12V to 18V or 6V to 12V? Wiring Questions?
By johneyboy03
#150808
Hi Guy's i own a Power wheel jeep 86219 since i'm 4 years old (now 31). My little daughter is now 2 years old and i start to repair thing on the jeep. I have try yesterday during lunch a new set of battery (two 6 volts battery) and everything was working fine, low, high, reverse.

But this morning after recharging the battery i start seeing smoke on one of the battery terminal (using emergency light sealed battery). I may have misplaced the connector on the battery. Having put the connector at the right place (like yesterday during lunch) the high speed doesn't work anymore and it wont reverse when swith is high mode. But on the low mode it will work on forward and reverse.

i did test both switch with my continious tester and they are ok.

Dont know if this problem happen to other but know i just dont know where to looking for. Hope someone will have a clue to help my out on this issus.
60223612_629617214171414_3587051987201425408_n.jpg
60223612_629617214171414_3587051987201425408_n.jpg (615.44 KiB) Viewed 133 times


Software Testing

It's like this and like that and like this and tha[…]

New Here!

Thanks but I only have 1 battery

Peg Perego Magica parts

Bumper,both motors,gas pedal,rear shocks, I'm camp[…]

HobbyMasters Udemy Course