Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Adding R/C to your Powerwheels vehicles? Using R/C parts on your Powerwheels?
User avatar
By OneAdam12
#147230
I replaced the 6v battery with a 12v but when I turn the car on and moved in any direction, it just pushed forward at full speed and stopped taking RC input.

I assume it's too much voltage for the RC module, can I some how separate it? I am not sure about how to do that. There are tons of wires, some are for the lights and speakers.

Here is the wiring under the seat.

Image
#147270
It won't be trivial if you're not sure, but if you get some pictures of the PCB (without the case) top and bottom, I can probably tell you what you need to modify.

The modification would require buying a part (ideally a buck convertor - £/$ 1-2), setting it (requires a multi-meter), cutting some PCB tracks and soldering.

Basically, it would be separating the logic power and placing the convertor in-between to keep that at 6v, allowing the rest of the circuit to stay at 12v+.
It would also mean that a 16/18v upgrade later would mean no other changes.

http://www.amazon.com/dp/B00A82A3RK/ref=cm_sw_r_cp[…]

French people ??

Is there some french people here ? I have a lot o[…]

Blown fuse in high gear

I have a 24v monster jam grave digger with the mlt[…]

Interested in the Barbie Escalade Sheet W6203-031[…]

HobbyMasters Udemy Course