Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Have you added running lights? Headlamps? Perhaps some spinners?
User avatar
By twisterdude1009
#146266
I want to know if anyone out there has put any speaker setups that did not use a amp board like a lepai but used a 4 channel amp (2 channels for highs 1 channel bridge for low) or used an entire setup (car deck and amp)
I want to see if it is doable for battery life. I know going the car amp route will sound way better and I will be able to get a thumpin subwoofer but I dont want it to sound amazing for 30 minutes and drain the battery. Check out my project page its the one with the Fire Rescue Jeep. Im planning on having a 50AH battery at minimum for the accessories.
I was looking at this car amp Crunch PX-1000.4. My other plan was to use a 2.1 amp board hooked up to crossovers to a horn tweeter and 5-1/4 mid drive, then have an 8 inch sub and an 8 inch passive radiator on the back. (Original was just to use 2 5-1/4 full range car speakers, but I have since changed that)

The Stage IV Motor/Gearbox kit is your best bet fo[…]

Starwars X-wing fighter gear box?

Hi, I have a striped gear in my son's X-wing fight[…]

Sportsman Twin 700's seem sluggish

I have 2 Peg-Pergeo Sportsman 700's. Both have ne[…]

PHASE 3 - PART 3 - ESC (Electronic Speed Controlle[…]

HobbyMasters Udemy Course