Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Anything that doesn't fit somewhere else & general forum updates
User avatar
By Sebgaut01
#146901
Hello, I have a Peg Perego RZR 24v, I had a problem, it did not work, so I ordered a new pedal, a new board and the reverse switch. I changed everything, now it works, contrary when I push the pedal the truck goes in reverse. I try to connect the old board, same result. Then I reconnected the old reverse switch, same result. I was wondering if the polarity of the motor could be the problem, I have two new 350w engine that I had to install but it currently has both original engines.
I do not understand my problem, the wires on my pedal are well connected, red top, middle white and blue below, the contact switches are clean.

So I still have the engines to know if I can reverse polarity. I also replace my batteries with Enerwatt 12v14mah ..
So I need help !! thanks
User avatar
By Bigmac41288b
#146902
When you replaced the batteries did you get the polarity correct? If those are installed backwards it would switch everything in the system to work backwards.
Where to find batteries

I like to take computer UPS's and use the batterie[…]

I’m trying to find headlights for this Jeep. They[…]

Most of the ESCs should have current limiting buil[…]

Lightning McQueen wiring help

Collage_Fotor.jpg

HobbyMasters Udemy Course