- Fri Jul 10, 2015 7:02 am
Use a DVOM reading voltage, hold the gas pedal down, put your ground lead on the battery and then the power lead, start tracing from the battery, to the pedal, to the shift switches, to the motors, and so forth until you find the place where you are losing your power. It's unlikely for both motors to go bad when you are testing in "high". If you are testing in "low" or "reverse" then one bad motor (or connection) would keep both sides from working.
"I'm not nuts, I prefer to be called an enthusiast! "
"I've stood on the shoulders of geniuses, and taken the next step..."
Master Project List
(F150 6x6, 36v Superpower, 24v Beach Ranger 4x4, McQueen "El Relampago", 36v Polaris, Mudvette, Lil jeep dragster & mudder, 36v Rzr, Lifted Cowboy's jeep, FJ cruiser, Lil quad 18v, etc...)
Toycrushers Master Wiring Diagrams