Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
vehicles with a circuit board controlling the motors
By burritoman5000
#70442
Hello to all from San Jose Ca, I read the stickies and all that but due to me being a newbie or impatience...or both I want to just list what I am trying to do and if anyone can help me...

I have a blue Harley...it is a six volt...I do not think there is a chipboard the wiring seems very simple... wiring is from battery to reverse and forward switch, engine, gas pedal...and the engine is on the right side rear with like a drive shaft that connects the two tires.... here are some photos.

Image

Image

Image

Image
User avatar
By sea_stork
#70704
I read it real slow, and still can't find the question. Anyway, what do you need assistance with? This is the low current 6v section and does not see much traffic.

That is a Super 6V ride on and will go real fast on 12v. The low current 6v are not as tough and only have one motor and GB.
By burritoman5000
#71646
ok thanks for the response...I want to change this to a 12volt battery...however I suppose I should re-post in the super six category...thanks I am a total newbie

Thanks. Yea I hear ya, our kids wear helmets too b[…]

Quad Damage (1st gear delete mod)

Awesome. Dude, you're a machine! I thought I was[…]

Does it do this with the batteries fully charged?

Sounds normal to me. Since it's a series circuit […]

HobbyMasters Udemy Course