Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
vehicles Without circuit a board controlling the motors
User avatar
By Dario
#147073
Have an Avigo Audi with a single rear motor. Original 6V car that I upgraded to 12v. No other mods except for removing the thermal switch near the battery (ha!). I just bought two new 12v motors from eBay but haven't installed them yet.

Kid was driving the car down a steep hill and I was running after her. I smelled that telltale melting wiring smell stopped her. Immediately saw some smoking, melted wires.

This car has no board and is very simple. On/off switch, forward/reverse switch, and a pedal. Guessing something shorted -
not sure how else the wiring gets that hot.

Will rewire, test switches and get new motors installed. Any thing I'm overlooking? And suggestions?

Thanks much.


User avatar
By Dario
#147078
Yep, will go 10g stranded just to be safe. Still don't get how/why the stock wires would have gotten hot enough to smoke at several points along the wires.
Volts/ current regulator

Many thanks again dude. Sorry to keep asking quest[…]

H4805 Linkage Help Part B7659-9419D

Hello all! Found the part through The Shop Vac No[…]

I am just confused about that resistor. Actually I[…]

Foward reverse gear help

The ram dually toy foward reverse lever handle sw[…]

HobbyMasters Udemy Course