Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
for 12v vehicles that NEED to be upgraded to 18v
#149950
Im doing this major overhaul of my daughter's PW Escalade and finally got to the Motor phase. 12v wired in series, 775s with MLToys metal enhanced gearboxes. 40 amp circuit breaker in line at battery. On the first test drive, she was gleefully sailing along in high gear, faster then shes ever been, and 5 mins in the circuit breaker started tripping. So, I had her stay in low gear for rest of trip.
Now, ive identified what might be causing a short, and I will address it immediately following this post. If it is not a short tho, what are my options? Can I simply purchase a 50 or 60 amp circuit breaker, or is it way more involved than that?


#149955
Ok, just checked troubleshooting and I think the shiftrr assembly is a good place to start. Found a replacement shifter switch, but what do you call the little white housing that the wires enter, that attaches to the shifter? May as well replace the whole unit. Thanks.
20181021_023427.jpg
20181021_023427.jpg (2.78 MiB) Viewed 1093 times

I saw that they sell 24 volt motors on Amazon they[…]

So I saw on Amazon that they sell 24v gears it say[…]

Batmobile- 1992 Power Drivers

I'd try to plastic weld the cracks, pretty easy to[…]

Plasti-dip

I wouldn't recommend it. I've dipped my Hayabusa […]

HobbyMasters Udemy Course