Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260
New here but not to the car scene

Hey guys! We have some ride on cars and one Merce[…]

http://www.amazon.com/dp/B00A82A3RK/ref=cm_sw_r_cp[…]

French people ??

Is there some french people here ? I have a lot o[…]

Blown fuse in high gear

I have a 24v monster jam grave digger with the mlt[…]

HobbyMasters Udemy Course