Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260
AMAV Power Rider 9539 parts?

I picked up one of them off kijiji. It was a littl[…]

Power wheel moves on its own

Well I have a brake relay for the brake pedal ,is […]

Hello All

Hey I am John From Utah here for insights and hel[…]

Hi guys I'm Ben

Hey I'm new here. Just got a used dune racer cheap[…]

HobbyMasters Udemy Course