Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

viewtopic.php?t=10260
Kawasaki Red Brute Force - Wiring

For the tip switches, there are two momentary pu[…]

Front Wheel Cut Off Sensor

I heard Seastork talking about this the other da[…]

Brute Force wiring harness

Those are microswitches that kill power through […]

Kawasaki Brute Force; No reverse

What you just said, is kinda normal. Reverse and[…]

HobbyMasters Udemy Course