Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260
Need wiring help

Note that diagram shows the accelerator as a poten[…]

Motion Trendz Buzz Lightyear Car

So has anyone found a good place to find these gea[…]

Dune racer build up help

You can go with the Banebots with either tooth opt[…]

Exploding Controllers

I would double-check the battery/wiring polarity -[…]

HobbyMasters Udemy Course