Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260

Yes, You can run them in series but it's no[…]

Circuit breaker popping

You can test the motors by applying 12v straight f[…]

Adjustable Brake Reduction Mod

Thank you so much for this idea! I was just going […]

I read the FAQ - The Definitive "Gearbox"[…]

HobbyMasters Udemy Course