Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260
lets fix the radio in a barbie jeep

if you mean the radio, it's just a cheap thing fro[…]

Huffy Lightning McQueen

Hello guys. I have a Huffy Lightning McQueen car w[…]

It's normal to do that when raised in the air. If […]

Sweet ride! That sand was packed compared to the d[…]

HobbyMasters Udemy Course