Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260

I can't believe no reply so far on a great site, I[…]

Upgrade from 6V to 12V

Hello, I have two-engine (6V 15W) ride-on car wit[…]

We're proud to announce our new Motor Upgrade pack[…]

Sweet build! I’m doing lights on my daughters Jee[…]

HobbyMasters Udemy Course