Page 1 of 1

1st thing: how to remove wheels

PostPosted:Sun May 06, 2018 4:06 am
by Lele
Hi all,

as i described in the subject i am here to ask you how to remove wheels because after removing the ferrari logo caps in the center of the wheel there isn'n any tipe of screws and trying to pull the rounded head rivet seems to be difficult and dangerous for the wheel itself (as you can see in attached images the bearing is visibile under the rivet)...

Image

So what's to do?

I really appreciate any help...

Emanuele

Re: 1st thing: how to remove wheels

PostPosted:Sun May 06, 2018 9:57 am
by wired
What is the manufacturer/brand name? It is probably a pushnut. The manufacturers website may have a parts list. Pushnuts are not made to be re-used and often get destroyed when trying to remove. There is a removal tool available but a little patience and a large set of slip joint pliers will do the trick.

Re: 1st thing: how to remove wheels

PostPosted:Mon May 07, 2018 8:29 am
by Lele
Thank You for your reply,

It's a Feber Ferrari FF...

Re: 1st thing: how to remove wheels

PostPosted:Tue May 08, 2018 2:48 am
by Lele
I've checked the manufacturer website but there is no evidence of complete part list..
So i wanna ask you if is possible to renew the steel bar with threading it at the end to screw with an exagonal (normal) nut...

Re: 1st thing: how to remove wheels

PostPosted:Tue May 08, 2018 4:24 am
by Avigo Range Rover
Just buy 7/16” wheel retainers. Reusable and locks wheels perfect

http://eastcoastpowerup.com/Wheel_Retainer

Re: 1st thing: how to remove wheels

PostPosted:Tue May 08, 2018 4:27 am
by Avigo Range Rover
Just check diameter of rod. I think feber uses 1/2” rods so may need 1/2” wheel retainer

Re: 1st thing: how to remove wheels

PostPosted:Tue May 08, 2018 2:48 pm
by Lele
Thank you Avigo,
i go to search immediately