Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new motors? Grind a gearbox? Adding teeth to a pinion?
#144538
Hey fellas, the 12v battery died in the Peg Pergo gator and I picked up a 96v (8x 12v) cell for a APC UPS. I rewired it in a parallel series for 24V and rigged it up in the bed of the Gator. She ran like hell for a bit then got exhausted from the weight, I presume. (Probably 70+lbs over the rear wheels)
I picked up two 775 Mabuchis rated at 18V, 19K RPM and have a couple questions that I am hoping you guys can help with.
1. Will any 5mm 32p Pinon work, or do I have to find a 10T? (really hard to locate) Ideally I'd like to go down a tooth or two to give more lowend.
2. What is the trick to mesh up the 775 to the stock gear box? The face bolts are a little wider set.

Lastly a bonus question: I am gettting 25.6ish Volts off the battery bank, but at the motor hookups its lower. Is the pedal or something in between knocking down the voltage?

Thanks in Advance!
download_20170215_133252.jpg

download_20170215_133250.jpg

The originator of the Hurrican pneumatic tire thre[…]

Check out my RC Dune Racer

The finished product is a beach cart. https:[…]

You'll need a 12v battery and a 6v battery of matc[…]

Throttle switch

I was trying to check the inside of the petal swit[…]

HobbyMasters Udemy Course