Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new motors? Grind a gearbox? Adding teeth to a pinion?
User avatar
By dlgg7
#148325
What size motors will work in the gearbox to replace oem motors on the peg razor 900 running 18v? I have several PW cars and have 775 motors for them, but this is the first peg I'm trying to upgrade, THANKS!
User avatar
By dlgg7
#148347
I can't believe no reply so far on a great site, I admit its a peg, but I do have more PW's than pegs! How about does anyone know from the part # on the motor I can find the specs to wittle down what I can use?
#148353
I don't own any PEGs so I can't give you a ready answer, but if you had the gearbox out you could take measurements of the existing motor and that would at least allow you to determine the case size currently in use. And if you had it apart enough, you can count teeth on all of the gears and determine the gearing ratio and. That would allow you to model the speed and torque you'd get at the wheels for any given motor replacement. Then if you had a target speed you wanted it would be possible to at least evaluate motors against that criteria.
User avatar
By dlgg7
#148355
Yep Hammer, reckon I'll have to pull the motor back out and start. I didn't write down all the #'s on the case but not to hard to get back to that. Trying to supe-up the polaris while I have 2 of the dune racers torn down too overhauling them during the winter for the grandkids! Hmmm, now what to think ahead for the gator and 2 jeeps and KFX and GD 4 whlr and ?????? You think you'll be doing this when your 61!!!

Yep Hammer, reckon I'll have to pull the motor ba[…]

Did you figure out why you where blowing motors? […]

Solar Panels?

If i have a 12V/20W solar panel with a 9.5Ah 12V P[…]

HobbyMasters Udemy Course