Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new motors? Grind a gearbox? Adding teeth to a pinion?
#148866
Hello,
I have been speaking to the folks at http://www.robotmarketplace.com trying to figure out what motor to use in this car. Price Fisher said it was a 6 or 12V with a 10 tooth gear attached. I misplaced the note so am not certain at this point which it is.
The motor that came out of it does not run at all.
Any help as to where to get these little motors would be appreciated.
#148867
GrandpaChar wrote:Hello,
I have been speaking to the folks at http://www.robotmarketplace.com trying to figure out what motor to use in this car. Price Fisher said it was a 6 or 12V with a 10 tooth gear attached. I misplaced the note so am not certain at this point which it is.
The motor that came out of it does not run at all.
Any help as to where to get these little motors would be appreciated.

i am curious, can’t seem to find this anywhere. bu[…]

Dune racer build up help

I haven't tried any of the drill switches, but mos[…]

"Best" Choice JEEP

Chances of both motors failing are slim. Can you r[…]

Sounds like the relay coil may have failed. Make s[…]

HobbyMasters Udemy Course