Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Swapping wheels? Adding suspension? Adding traction mods? This is the place for anything between the body and the ground!
#147222
Here are some good links:

Factory axle is 7/16" and most of these pneumatic wheels have a 5/8" bore. As suggested below you can get a piece of 1/2 PEX pipe which has a 5/8" OD and is very close to 7/16". I'm currently waiting on some 7/16" to 5/8" flange bushing/bearings to tighten up the tolerances.

http://www.saltydog.com/powerwheels/

http://forum.modifiedpowerwheels.com/viewtopic.php?t=10260

Thank you hammer. Yes I was referring to the 7013,[…]

Thanks, I will try your suggestion! It’s is an e[…]

Texans in 2017?

We just got our Son a Jeep hurricane extreme. We[…]

Chain Drive Dune Racer Prep

Sprockets arrived yesterday so I got them attached[…]

HobbyMasters Udemy Course