Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
vehicles with a circuit board controlling the motors
User avatar
By Shabani88
#149167
Hey guys I’m looking to switch between 12v to 18v then 24v with 2 separate switches, so I have 3 battery’s, 2 of them are 6v 12ah ,and the other battery is 12v 12ah. I’m very familiar with wiring I did a set up, in my sons jeep to go from , 12v to 18v with a 30/40 amp automotive relay, and a 25-30 amp switch 12gag wire, but I can’t figure out out how inclule the last battery?? If any one can help that would been very appreciating
User avatar
By Shabani88
#149209
Thanks for All the help this add on is perfect for what I need to do. But I guess what I’m looking for is more like a three speed so 12, 18 than 24
User avatar
By CJB
#149213
It would be possible to use both my Turbo Timer and 18V board - have the timer automatically kick it from 12 to 18 after a time delay and then have a button for 18 to 24... Or you could go the two button route I suppose but that sounds like a lot to mess with while trying to steer too.

Sorry so delayed! What are you looking for in ter[…]

Selling Jeep Hurricane 24 volt

Hey Ernie I see the listing was removed. Is it sti[…]

Circuit breaker popping

So there is a lot of resistance when just spinning[…]

Shes alive again!! Replaced the foot pedal and all[…]

HobbyMasters Udemy Course