Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new motors? Grind a gearbox? Adding teeth to a pinion?
By Heisindc
#149926
Was planning on boosting my 3 yr olds corvette in a bit, but he loves to jam it from forward to reverse and back at full tilt. Sure enough something broke and it only works in reverse. Any guides or videos out there on opening it up for a novice? Thanks!


#150048


This shows the Dune Racer, but the Ford trucks, the jeep, many others use similar mechanisms. You likely need to replace the switch. In my son's mini cooper, the switch just quit working one day. I had to pull it out of the car, dunk it in water, warm it up with a heat gun to loosen the tabs and disassemble the switch. While apart, I brushed the contacts with a stainless brush reapplied dielectric grease, and then reassembled. It would keep working for a few months and I would have to repeat.

I have started the conversion process, added a sec[…]

Gaucho Grande gearboxes

I have a faded old Yellow Gaucho Grande I have bee[…]

It would be consistent if he only had 3 customers.[…]

Rubber Tires on 24v Grave Digger

New here, what's all done to it and how did you do[…]

HobbyMasters Udemy Course