Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Anything that doesn't fit somewhere else & general forum updates
User avatar
By Jkilmurray
#150472
I’m trying to put the brute force back together after ordering new parts. I ordered new back wheels and a new rear axle. But like the idiot I am, I threw away the old one. The new one is about 3 inches too short. But it’s the right part number. Even had local dealer order another to verify I didn’t get a bad one. It is on a black brute force x6646. The part number is r8126-4509. Verified correct in parts diagram and through service center. What am I doing wrong? The wheels won’t even go on with wheel drivers off of them. Any help is appreciated.

Thanks


User avatar
By Jkilmurray
#150473
Attaching parts diagram. New axle is 24” long. Fender to fender is 27”ish. And the wheels stick out a little past fender
2D8D7679-8E39-428D-BEFB-7C21F362E316.jpeg
2D8D7679-8E39-428D-BEFB-7C21F362E316.jpeg (150.17 KiB) Viewed 381 times

I recently upgraded my kids Dora Jeep from 6v to 1[…]

"Best Choice" Jeep?

Best Choice Products (BCP) Jeep 24v Upgraded from […]

Why should the kids have all the fun! Used this o[…]

All good. 8-) We're here to support each other an[…]

HobbyMasters Udemy Course