Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new batteries? Going from 12V to 18V or 6V to 12V? Wiring Questions?
By tacmor
#150708
I have a 12V Best Choice Jeep that has no power. Battery is good, I have replaced the control module, and about to replace the push button switch. Nothing has a hint of power, and it doesn't appear battery is charging via the charging port. Charger tested good. Any thoughts?


User avatar
By wired
#150710
I'd look for a blown fuse. If possible, charge the battery outside of the vehicle. Battery should read well over 12v while charging (may be as high as 14.5v). Battery should read over 12v after a full charge and resting for at least an hour (12.4-13v depending on battery health). Battery voltage should not drop below 10-ish volts when installed and throttle pedal depressed.
Volts/ current regulator

Many thanks. I had a go at this earlier today, how[…]

Need a help

Hi! This is my first build on upgrading my kids N[…]

I want to upgrade the motors to 775 with at least […]

Magic Cars modifications

Hello everyone, did anyone have any success with m[…]

HobbyMasters Udemy Course