Gruber
HobbyMasters
M.L. Toys
KidsWheels
Gruber
HobbyMasters
M.L. Toys
KidsWheels
HobbyMasters M.L. Toys
Gruber
KidsWheels
Need new batteries? Going from 12V to 18V or 6V to 12V? Wiring Questions?
By msgillett
#151114
We just purchased this sweet Bat mobile to rehab. Everything works but there is a short on the MB. A connection wiggles all car functions off and on. What is the best way to fix this?
Attachments
batcarMBlr.jpg
batcarMBlr.jpg (61.77 KiB) Viewed 208 times
batcar1.PNG
batcar1.PNG (305.69 KiB) Viewed 208 times


User avatar
By wired
#151117
That might be broken solder joints on the circuit board. Check the back side of the board and see if the solder joints at that plug are cracked or broken. If they are damaged, you would just need to re-flow solder (soldering iron or solder gun).
By msgillett
#151118
The back soldering looks good. The connection is tight. Could the inside connections be loose? Is there a way to fix then without replacing the connection housings?
User avatar
By wired
#151129
A good cleaning of the connections wouldn't hurt anything. Some circuit board cleaner and a soft wire brush should remove any light corrosion. It's amazing how little it takes to disrupt a good connection. I like to use isopropyl alcohol to rinse off a circuit board after cleaning to remove left over residues.
Volts/ current regulator

A PWM ( pulse with modulator) will do the trick it[…]

Trailers

Sounds awesome! I just ordered everything to male[…]

Peg Perego axle diameter

The axle rod is 7/16. I just replaced one with a t[…]

Just converted a Peg Perego Gator and tractor to u[…]

HobbyMasters Udemy Course